浅埋软弱地层隧道旋喷预衬砌支护技术的研究   总被引：3，自引：0，他引：3       下载免费PDF全文

李远宁  段玉刚吴胜 《探矿工程》2001,(5):58-61

论述了浅埋软弱地层隧道旋喷预衬砌支护的研究背景及国内外研究现状、室内试验、旋喷器具、施工工艺及应用情况,并与其它施工方法进行了对比,效益显著。  相似文献   

气相色谱和薄层色谱法在形态分析中的应用   总被引：2，自引：0，他引：2  

方国桢  方梅 《岩矿测试》1996,15(4):299-310

评述了气相色谱和薄层色谱法用于氯、溴、碘、硫、硒、碲、铬、氮、磷、砷、钒、碳、锡、铅、铁和汞１６种元素的不同形态分析的进展。这些形态包括不同价态、有机态、无机态、阳离子和阴离子态等。由于气相色谱和薄层色谱法都具有分离和检测两种功能结合的特点，因此它们是用于元素形态分析的有效和方便的方法。引用１９８０～１９９４年文献９２篇  相似文献   

不等电极距情况下高密度电阻率法的反演结果分析     

吴云超  王传雷  陈超 《物探与化探》2005,29(1):19-21

通过高密度电阻率法的模型实验,得出不等电极距情况对直立高阻薄板和低阻球体反演结果的影响:缺失电极对它正下方的ρ_s影响最大,而异常形态主要在水平方向有明显的变化,异常体随电极缺失的位置有趋势变化,电极缺失的数目越多,异常形态变化越大,但是从整体来看反演剖面图基本相似。  相似文献   

An Upper Pliocene coarse pumice breccia generated by a shallow submarine explosive eruption,Milos, Greece     

Andrew?L.?StewartEmail author  Jocelyn?McPhie 《Bulletin of Volcanology》2004,66(1):15-28

The Filakopi Pumice Breccia (FPB) is a very well exposed, Pliocene volcaniclastic unit on Milos, Greece, and has a minimum bulk volume of 1 km³. It consists of three main units: (A) basal lithic breccia (4–8 m) mainly composed of angular to subangular, andesitic and dacitic clasts up to 2.6 m in diameter; (B) very thickly bedded, poorly sorted pumice breccia (16–17 m); and (C) very thick, reversely graded, grain-supported, coarse pumice breccia (6.5–20 m), at the top. The depositional setting is well constrained as shallow marine (up to a few hundred metres) by overlying fossiliferous and bioturbated mudstone. This large volume of fine pumice clasts is interpreted to be the product of an explosive eruption from a submarine vent because: (1) pumice clasts are the dominant component; (2) the coarse pumice clasts (>64 mm) have complete quenched margins; (3) very large (>1 m) pumice clasts are common; (4) overall, the formation shows good hydraulic sorting; and (5) a significant volume of ash was deposited together with the coarsest pyroclasts.The bed forms in units A and B suggest deposition from lithic-rich and pumiceous, respectively, submarine gravity currents. In unit C, the coarse (up to 6.5 m) pumice clasts are set in matrix that grades upwards from diffusely stratified, fine (1–2 cm) pumice clasts at the base to laminated shard rich mud at the top. The coarse pumice clasts in unit C were settled from suspension and the framework was progressively infilled by fine pumice clasts from waning traction currents and then by water-settled ash. The FPB displays important features of the products of submarine explosive eruptions that result from the ambient fluid being seawater, rather than volcanic gas or air. In particular, submarine pyroclastic deposits are characterised by the presence of very coarse juvenile pumice clasts, pumice clasts with complete quenched rims, and good hydraulic sorting.Electronic Supplementary Material Supplementary material is available for this article if you access the article at . A link in the frame on the left on that page takes you directly to the supplementary material.Editorial responsibility: J. Donelly-Nolan  相似文献   

均匀充电矩形薄板电场复形调优反演计算     

李建林  张庆  倪根生 《物探化探计算技术》2000,22(3):254-256

针对充电电场反演计算参数较多以及复形调优算法处理约束条件的直接有效性,作者就均匀充电矩形薄板反演问题编制程序,计算地质体理深、倾角及大小。尽管迭代次数较高,计算结果颇为理想,取得了较好的效果。  相似文献   

吉林省长白山天池新生代火山喷发作用及火山灾害的环境效应     

王彦生  彭玉鲸  靳克  许文良 《吉林地质》2000,19(4):25-32

通过对吉林省长白山天池火山的研究及１：５万区域地质调查资料,将区内新生代上新世以来的火山活动划分为４个火山喷发旋回及１３个火山喷发期,对爆发性火山作用划分了岩浆型、蒸气－岩浆型（岩浆－蒸气型）和蒸气型三种类型。火山喷发动力学机制的研究,对长白山天池火山的稳定性作出补步评价,在此基础上,对该区生代上新世以来的火山喷发作用及其引发的火山灾害的环境效应进行了论述。并对火山喷发作用所产生的积极环境效应,提出了合理开发和利用的建议。  相似文献   

Explosive volcanic eruptions—X. The influence of pyroclast size distributions and released magma gas contents on the eruption velocities of pyroclasts and gas in Hawaiian and Plinian eruptions     

Lionel Wilson 《Geophysical Journal International》1999,136(3):609-619

Previous treatments of the relationship between the mass fraction of released magma volatiles and the eruption speeds of gas and pyroclasts in steady explosive eruptions have not taken detailed account of the dynamic effects associated with the finite size distribution of the pyroclasts. When this is done, it is found that previously published estimates of exsolved magma volatile contents obtained from the analysis of pyroclast size distributions in near-vent deposits overestimate the volatile content by approximately 20 per cent in the case of Plinian eruptions. The discrepancy is much worse for pyroclast size distributions skewed towards coarse clasts, as is common in basaltic lava fountains; in such cases pyroclast dispersal studies may overestimate the exsolved magma volatile content by at least 200 per cent. An analogous problem arises if released magma volatile amounts deduced from studies of fluid inclusions in pyroclasts are inserted into most current computer models of eruption dynamics, but the gas eruption speeds deduced have an even larger error, being underestimated by up to 300 per cent in the case of coarse-grained eruptions. The more sophisticated of the currently available numerical models of eruption dynamics can in principle avoid this problem, but practical implementation limitations have so far prevented such models being run with a sufficiently wide range of grain sizes for the importance of these effects to be fully appreciated.  相似文献   

硫铁矿地下深井巷堵水工程设计     

罗继辉 《水文地质工程地质》1999,26(2):57-59

本文工程设计阐述了在动水条件下,封堵水平巷道的“三段式”组合灌浆方法,以及定向钻进在地下深井巷堵水工程中的应用。  相似文献   

提高薄壁金刚石钻头经济效益的途径          下载免费PDF全文

蔡家品 《探矿工程》1999,(1):45-46,48

对薄壁金钢石钻头应用领域进行了介绍,并从钻头制造和使用及钻头磨损等方面提出了薄壁金刚石钻头经济效益的途径。  相似文献   

A three dimensional model of muckpile formation and grade boundary movement in open pit blasting     

R. L. Yang  A. Kavetsky 《Geotechnical and Geological Engineering》1990,8(1):13-34

Summary Formulation and case studies of a three dimensional kinematic model are presented. Thein situ overburden geometry can be simulated accurately and various initiation patterns of blasts can be modelled. The overburden geometry, hole patterns and explosive distribution are all explicit model inputs. Because the effect of explosive properties, rock mass condition and inter-row delay are very difficult to measure in terms of blast performance, these are represented in the model by control parameters which are left for calibration using field data. The output of the model is a three dimensional muckpile shape of any cross section and a contour map of grade distribution within the muckpile. Two case studies are presented which have shown that the model is a valuable tool for optimizing production blasting as well as for controlling grade dilution during blasting.  相似文献